|
GOOSENECKS
- Durable, galvanized rigid box frame construction. Closed design puts the feed in the silo, not on the roof. Messy closure plates not needed.
- Quick & easy to install compared to other brands.
- Factory preassembled for quality assurance.
- Heavy stainless steel liner turns the stream of feed and handles the initial impact.
- Choose from the largest selection anywhere.
- Choose 9" or 12" models. 12" width is recommended for haylage and greater blowing capacity.
- Expect many years of service If replacement is needed, replace the damaged section only.
- High profile goosenecks should be selected when available. These have a smooth arc to reduce friction. The end section is vertical and more accurately places the feed where you want it.
- Note: Goosenecks are available for most conical roof silos, such as Madison, Sealstore, Cropstore, Coleman, Mirastore and Simplex. Call for assistance.
HEAVY DUTY GOOSENECKS should be used in the following conditions:
- For high moisture grains
- For any feed with high horsepower on the blower (150 or more)
- For customers who insist on "top of the line" products
Shape and appearance is similar to a standard Level-Flo gooseneck, but the galvanized metal is heavier by 30%. In addition, the stainless steel liner that is in the first section is 65% heavier.
|
Top Unloading Silos
|
- Durable, rigid galvanized box frame construction on lower section. Upper section open on bottom, but firmly supported with extra bracing.
- Quick and easy to install, including mounting brackets, attaches to first two silo hoops.
- Factory preassembled for quality assurance.
- Heavy stainless steel liner turns the stream of feed and handles the initial impact.
- Choose from the largest selection anywhere. Choose 9" or 12" models. 12" width is recommended for haylage and greater blowing capacity.
- Expect many years of service If replacement is needed, replace the damaged section only.
- Center fill goosenecks discharge at the center of the silo, and are used with ring drive unloaders.
|
|
Model #1012
For use in 10' or 12' diameter silos
|
- Durable rigid galvanized box construction.
- Quick and easy to install, includes mounting brackets, attaches to first two silo hoops or lags to monolithic silo.
- End fins split the silage stream.
- Heavy stainless steel wear plate turns the stream of feed and handles the initial impact.
- Adjustment makes it easy to top out silo.
|
|
Model #680
Sealed pipe, Side Center-Fill System
|
- Ground controls, no need to climb silo
- Air tight 10-inch Stainless Steel Gooseneck
- Stainless Steel Guide Chute
- Sure-Seal Air Escape Vent - 24"
- Stainless Steel Center Baffle
- 24" Center Hatch /Locking Cover
- Pipe Closure
- 3-foot Stainless Steel Telescope
- Hardware and Sealant
- Use with 10" heavy wall vinyl pipe
|
|
 |
